Turnigy Dlux User Manual

Hextronik AIRplane [6-12]ESC Manual [ Model 2 ] Page 2 7/21/2014
Switch Frequency : 8KHz
RPM Control : Off
How to program your controller
 Switch on the transmitter and push to the throttle stick to full throttle.
 Connects the motor battery pack and turns on the receiver (BEC) switch.
 Waits for 5 sec, you’ll hear tones; setup mode is entered: __ --
 When you hear the desired tones, pull the throttle down, then you’ll hear two confirmation tones. The setting is now
memorized.
 You can only change one setting at a time, if you need to change more settings, disconnect the motor battery pack and wait 5
second, and repeat above procedure for next setting.
 You can exit the programming mode at any time if you pull out the battery connector from ESC.
1. Setting up the propeller Brake on or off
Follow above procedure enter to the programming mode.
If you pull the throttle stick to off within 5 sec, Brake will be changed. (ON  OFF, or OFF  ON)
2. Battery Type
(select battery type which is being used in your model)
Nimh/Nicd:
Lipo 6S
x 3
Lipo 7S
x 3
....... ....... ....... ....... .......
Lipo 8S
x 3
........ ........ ........ ........ ........
Lipo 9S
x 3
......... ......... ......... ......... .........
Lipo 10S
x 3
Lipo 11S
x 3
Lipo 12S
x 3
Lipo 13S

Turnigy Dlux Specifications

General

Brand	Turnigy
Model	Dlux
Category	Controller
Language	English