Turtle Beach RECON CLOUD - Regulatory Compliance Statements for the Recon Cloud Controller; Local Restrictions on Radio Usage; Federal Communications Commission (FCC) Compliance Notices; RF Radiation Exposure & Hazard Statements

Regulatory Compliance Statements for the Recon
™
Cloud Controller
Local Restrictions on Radio Usage
Caution: Due to the fact that the frequencies used by wireless devices may not yet be harmonized in all countries, these radio products are designed for use only
in specic countries, and are not allowed to be operated in countries other than those of designated use. As a user of these products, you are responsible for
ensuring that the products are used only in the countries for which they were intended and for verifying that they are congured with the correct selection
of frequency and channel for the country of use. Any deviation from the permissible power and frequency settings for the country of use is an infringement of
national law and may be punished as such.
To determine whether you are allowed to use your wireless network device in a specic country, please check to see if the radio type number that is printed on
the identication label of your device is listed in the manufacturer’s OEM Regulatory Guidance document at the following URL
http://www.turtlebeach.com/homologation or contact Turtle Beach directly.
Federal Communications Commission (FCC) Compliance Notices
This section includes the following FCC statements for the Recon™ Cloud Controller:
• Non-Modication Statement
• Class B Interference Statement
• RF Radiation Exposure & Hazard Warning
Caution: Any changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation. Any Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RF Radiation Exposure & Hazard Statements
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specic operating
instructions for satisfying RF exposure compliance. This transmitter must not co-located or operating in conjunction with any other antenna or transmitter.