Turtleplay Kids Adirondack Chair Kit

To Next Page

ADC0292200000 - KIDS ADIRONDACK CHAIR KIT

turtleplay

CARE INSTRUCTIONS

The Kids Adirondack Chair Kit has been conditioned for outdoor use with a weather

resistant stain. To maintain the beauty and life expectancy of the Kids Adirondack Chair

Kit, it is HIGHLY RECOMMENDED that you treat the chair with a weather proof stain once

a year.

-Rinse any panels with water to clean.

-When assembling turtleplay

™ products please handle all panels and/or

hardware with care to avoid any possibilities of damage and/or injury.

NOTE: Please read all instructions carefully before starting assembly.

Also, we recommend that the unit is fully assembled on a level surface.

Two people are recommended to assemble this product.

Main Page

Need help?

Do you have a question about the Turtleplay Kids Adirondack Chair Kit and is the answer not in the manual?

Summary

Care Instructions

Panel Cleaning

Rinse any panels with water to clean.

Assembly Handling Precautions

Handle panels and hardware with care to avoid damage or injury during assembly.

Assembly Recommendations

Read instructions, assemble on a level surface, with two people.

Part List

Seat Slats

Component identification for 5 seat slats.

Rear Seat Slat

Component identification for 1 rear seat slat.

Angled Legs;Seat Frame

Component identification for 2 angled legs/seat frames.

Rear Seat Stretcher

Component identification for 1 rear seat stretcher.

Arm Support

Component identification for 2 arm supports.

Front Legs

Component identification for 2 front legs.

Parts and Hardware List

Arms

Component identification for 2 arms.

Top Backrest Stretcher

Component identification for 1 top backrest stretcher.

Bottom Backrest Stretcher

Component identification for 1 bottom backrest stretcher.

Outer Backrest Slat

Component identification for 2 outer backrest slats.

Inner Backrest Slat

Component identification for 2 inner backrest slats.

Mid Backrest Stretcher

Component identification for 1 mid backrest stretcher.

Arm Underside Brackets

Component identification for 2 arm underside brackets.

Hardware A (3.5 x35 mm)

Hardware identification for 38+1 pieces of 3.5x35mm screws.

Hardware B (3.5 x30 mm)

Hardware identification for 8 pieces of 3.5x30mm screws.

Hardware C (M6 x45)

Hardware identification for 4 pieces of M6x45 screws.

Assembly Steps

Contact and Support