2.
Package and Hardware Contents Product Specifications
Maximum Flow Rate: 1.8 GPM (6.8 LPM)
@ 60 PSI
ASME A112.18.1/CSA B125
NSF/ANSI/CAN 61: Q ≤ 1
Ceramic cartridge
Manufactured to include no more than 0.25%
weighted average lead content on wetted
surfaces
PART DESCRIPTION
QUANTITY
A Faucet body 1
B Deckplate (optional) 1
C Gasket (optional) 1
D Quick-install mounting nut 1
E Metal washer 1
F Rubber washer 1
Due to constant design and quality improvements, the product may look slightly different
from the picture.
Safety Information
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING:
• Protect your eyes with safety glasses when installing faucet or working on water supply lines.
CAUTION:
• Cover the sink drain to avoid losing parts.
Preparation
Before beginning assembly of product, make sure all parts are present. Compare parts with the package and hardware
contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 30 minutes
Tools Required for Assembly (not included): Adjustable wrenches, slip joint pliers, and silicone.
Installation may vary depending on how the previous faucet was installed. Supplies necessary for the installation of the
faucet are not all included; however, they are available wherever plumbing supplies are sold.
Prior to beginning installation, turn off the hot and cold water lines, then turn on the old faucet to release built-up
pressure. When installing the new faucet, tighten the supply line connections using an adjustable or basin wrench.
DO NOT OVERTIGHTEN. Connections that are too tight will reduce the integrity of the system.
Need Help? Please call our toll-free line at (877) 319-3757 (7:30 am to 4:30 pm CST) for additional assistance or service.
B
A
D
F
E
C
To Next Page
Loading...