Installation
Follow these steps for a seamless setup:
3.Installation:
Using screws: Position, drill, and secure.
Using tape: Clean and attach.
4.Alignment Check:Ensure they match up.
Close the door or window to confirm
the gap.
5.Testing:Open and close the door or
window to confirm accuracy.
1.Placement:Install the sensor on the door or
window, and place the magnet on the door frame
or window frame. Ensure that the gap between
the sensor and magnet is less than 10mm when
the door or window is closed.
2.Marking:Use a pencil or tape to mark where
they should be positioned.
24
To Next Page
Loading...
