38
13c. Trip meter
Trip meter indicates the trip distance travelled in
kilometer. The digit after the dot mark denotes the
one tenth of a kilometer.
Provision to measure two different distance ‘TRIP 1’
or ‘TRIP 2’ is provided for the users to use as per
their convenience.
Whenever the vehicle speed crosses the previously
achieved high speed, the speedometer flashes the
high speed data at the rate of 2 Hz till the speed
comes less than 3 km/h. This will happen in all modes
except shortest time mode.
Maximum speed recorded so far will be displayed
whenever the meter is set in ‘HIGH SPEED’ mode.
This display will go off automatically once the vehicle
starts moving (>3 km/h) and it will continue the normal
operation.
Max speed recorded will be stored until manual reset. If
the high speed is reset, the speed value will be shown
as ’0’.
13d. High speed indicator
High speed indicator records the maximum speed
(top speed) achieved by the rider so far in km/h. You
can reset and record the new speed if required. Refer
page no. 43 for resetting the high speed data.
Set the meter in ‘HIGH SPEED’ mode to know
the maximum speed achieved by any user so far.
To Next Page
Loading...
