29
MPH and KMPH setting
• Ensure the display is in ‘ODO’ mode.
• Press and hold the Mode button for few seconds
till the display enters ‘ ‘. Press
the Set button to select the MPH mode.
• To change the display to KMPH mode again,
press and hold the Mode button till the display
enters ‘ ‘. Press Set button to
select the KMPH mode.
Digital clock setting
• Ensure the display is in ‘ODO’ mode.
• Press and hold the Mode button for few seconds
till the display enters ‘SET mph MODE’ or ‘SET
kmph MODE’ (based on preferred setting).
• Release and press the Mode button once again
so that the display enters ‘ ‘
mode.
• On pressing the Set button, if the clock is in
12 hours format, the hour format ‘AM’ or ‘PM’
blinks. Else the clock will be ready for 24 hours
format selection.
• Press the Mode button to change the hour format
‘AM’ or ‘PM’ or to change the clock to 24 hours
format.
• If the clock is in 24 hours format press the Mode
button once again to set the clock to 12 hours
format.
• Press the Set button again so that the hours digit
of the clock blinks.
• Now, press the Mode button to increase the
hours while hour digits are blinking.
• On pressing the Set button again the hours of the
clock is set and the minute digit blinks.
• Now, press the Mode button to increase the
minutes while minute digits are blinking.
• Press the Set button again to set minutes and to
come out from clock setting.
If the display is set to MPH mode, it will switch to KMPH
mode by default whenever the ignition is turned ‘OFF’
and ‘ON’.
To Next Page
Loading...
Need help?
General
