36
4. On pressing the Set button, if the clock is in
12 hours format, the hour format ‘AM’ or ‘PM’
blinks. Else the clock will be ready for 24 hours
format selection.
5. Press the Mode button to change the hour format
‘AM’ or ‘PM’ or to change the clock to 24 hours
format.
6. If the clock is in 24 hours format press the Mode
button once again to set the clock to 12 hours
format.
7. Press the Set button again so that the hours digit
of the clock blinks.
8. Now, press the Mode button to increase the
hours while hour digits are blinking.
9. On pressing the Set button again the hours of the
clock is set and the minute digit blinks.
10. Now, press the Mode button to increase the
minutes while minute digits are blinking.
11. Press the Set button again to set minutes and to
come out from clock setting.
Bluetooth pairing mode ‘ ‘
Using the Bluetooth pairing mode the connected
instrument cluster of ‘TVS Apache RTR 200 4V’ can
be connected to your Android™ smart phones and
iPhone
®
via Bluetooth
®
through a TVS CONNECT app
which can be download from Google Play and the
Apple store
®
.
Maximum of 3 devices of Android phones can be auto-
paired with the instrument cluster.
Only one iPhone can be auto-paired with a single
instrument cluster at a time. If the user need to connect
multiple iPhones with the single instrument cluster,
the previous connected iPhone has to be forgotten by
clicking, “Forget This Device” from Bluetooth settings in
the iPhone.
If the vehicle battery is reset or fuse is blown, then too
“Forget This Device” from Bluetooth settings in the
iPhone has to be done.
TVS CONNECT
If the Set button is pressed when the instrument cluster
is in normal operating mode like ‘ODO’, ‘TRIP’ etc.
following information will be popping out which is not
applicable to present model.
To Next Page
Loading...
