14
It is not necessary to have this pulsation feel every
time the brake is applied. Pulsations are felt only
during wheel locking tendency, occurs due to the
modulation of pressure in the brake circuit by HECU.
Pulsation means that the vehicle is in limit. This
pulsation feel also depends on the road condition.
ABS warning lamp
The TVS Apache RTR 160 does an automatic self
check every time when the ignition switch is
turned ‘ON’. The ABS warning lamp provided at the
speedometer console blinks and informs you that the
ABS is under check.
This ABS warning lamp goes ‘OFF’ once the bike
reaches 7 km/h speed and above and the ABS
warning lamp blinks whenever the bike speed is less
than 7 km/h speed indicating that the ABS is working
fine.
If the warning lamp glows continuously even after
the bike crossing 7 km/h speed or if the ABS lamp
is not blinking or glowing at all, then the ABS has
an error and your bike should be taken to any of our
nearest TVS Motor Company Authorised Main Dealer
/ Authorised Dealer.
DO‘S AND DON’Ts
Do’s
Check the ABS warning lamp for any warning
before driving the vehicle.
Apply both front and rear brake for better
performance.
Apply continuous brake in ABS mode for better
performance. Do not pump.
Perform the periodic maintenance as per the
schedule.
ABS should be serviced only at TVS Motor
Company Authorised Main Dealer / Authorised
Dealer.
AB
To Next Page
Loading...
Need help?
General
