12
If the warning lamp glows continuously even after
the bike crossing the specified speed limits, then the
ABS has an error and your bike should be taken to
any of our nearest TVS Motor Company Authorised
Main dealer / Authorised Dealer for inspection.
DO‘S AND DONT‘S
Do’s
Check the ABS warning lamp for any warning
before driving the vehicle.
Apply both front and rear brake for better
performance.
Apply continuous brake for better performance.
Do not pump.
Perform the periodic maintenance as per the
schedule.
ABS should be serviced only at TVS Motor
Company Authorised Main Dealer / Authorised
Dealer.
Carefully remove the wheels during puncture /
tyre replacement to prevent toner ring damage
/ bend.
Keep the wheel in such a way that the toner
ring is facing upwards.
ABS helps only in improving the vehicle control. It is
always good to remember not to exceed the physical
limits of the vehicle stability. It is rider’s responsibility to
ride at a suitable speed, while taking care of conditions
and road surface. ABS will not compensate for errors
in the judgement or improper brake use in the various
situation. ABS never eliminates the danger of falling
while turning.
Hard braking during sharp cornering on slippery surface
may lead to vehicle instability. Under such circumstances
gradual braking is recommended.
Always use recommended brake fluid. Use fresh,
clean brake fluid.
Use only the recommended make, type and size
of tyre (ABS tuned with tyre specified by the TVS
Motor Company).
Dont’s
Do not use non-standard tyres.
Do not pump the brakes. Apply the brakes
continuously.
Do not ignore any warning lamp on speedometer.
Do not adjust the wheel speed sensor air gap
your self.
To Next Page
Loading...
