36
Once the split pins are removed, replace them with new
ones.
REAR WHEEL REMOVAL
1. Remove the rear brake adjuster nut (1) and
disconnect the brake cable from the brake panel
assembly.
2. Remove the split pin (2) and the nut (3).
Disconnect the torque link.
3. Remove the axle nut (4).
4. Pull out the axle (5) and take out the spacer from
the rear wheel assembly.
Always make sure that whenever the wheel is removed,
axle nut is properly re-tightened to the specified torque.
5. Tilt the vehicle to the left and take out the wheel
assembly along with the brake panel assembly.
6. Reverse the procedure for reassembly.
1
4
3
5
2
STORAGE PROCEDURES
For storage of your vehicle for longer periods of over
a month and above, we recommend to carry out the
following steps:
1. Clean the vehicle thoroughly. Park the vehicle on
center stand.
2. Empty the fuel tank.
3. Warm up the engine and drain engine cum
transmission oil. Store the oil, if new, in a dust
free container.
4. Remove the spark plug and feed in several drops
of engine cum transmission oil through spark plug
hole. Crank the engine few times and reinstall the
spark plug.
5. Remove the battery, store it away from direct
sunlight and freezing temperatures.
To Next Page
