TVT TD-9422S3 User Manual

Package
Overview
Installation
1
2
3
4
► Connecting Network Cable
① Loosen the nut from the main element.
② Run the network cable (without RJ 45 connector) through the
both elements. Then crimp the cable with RJ 45 connector.
③ Connect the cable to the hermetic connector. Then tighten the
nut and the main cover.
Warning and Caution
■ If the product does not work properly, please contact your dealer
or the nearest service center. Never attempt to disassemble the
camera yourself. (We shall not be responsible for any problems
caused by unauthorized repair or maintenance.)
■ In the use of the product, you must be strict compliance with the
electrical safety regulations of the nation and region. When the
product is mounted on wall or ceiling, the device shall be firmly
fixed.
■ Do not allow water or liquid intrusion into the camera.
Do not use camera beyond specified voltage range.
■ Do not drop the camera or subject it to physical shock.
■ Avoid touching the camera lens.
■ If cleaning is necessary, please use clean cloth to wipe it gently.
■ Do not aim the camera at the sun or extra bright place.
■ Do not place the camera in extremely hot, cold (the operating
temperature shall be -30˚C~60˚C), dusty or damp locations, and do
not expose it to high electromagnetic radiation.
■ To avoid heat accumulation, good ventilation is required for
operating environment.
■
Quick Start Guide
Network Camera
Please make sure that the wall or ceiling is strong enough to
withstand 3 times the weight of the camera. Please install the camera
under dry environment.
①
the drill template.
Drill the screw holes and the cable hole on the wall according to
Camera
Quick start guide
CD
Plastic plug × 4
Drill template
Rubber plug
4 tapping screws PA 4×25
1 machine screw PWM3×5
■ Please read this instruction carefully before operating the unit
and keep it for further reference.
■ All the examples and pictures used here are for reference only.
■ The contents of this manual are subject to change without
notice.
2
1
3
1 Fixed Ring
2 Mounting Base
3
4
Network connector*
Audio Input
* It is recommended to install the security cap for outdoor installation.
* If the PoE switch is used to power the camera, DC12V power supply is not
required.
Sec
urity
c
a
p
1
2
3
4
5
6
7
DC12V
5 Power connector*
6 Micro SD card slot
7 Reset

TVT TD-9422S3 Specifications

General

Brand	TVT
Model	TD-9422S3
Category	Security Camera
Language	English

Summary

General Warnings and Precautions

Safety and Operational Guidelines

Covers essential safety advice, including handling, environmental conditions, and usage restrictions to ensure proper operation and prevent damage.

Package Contents and Product Overview

Included Items and Component Identification

Lists all items included in the package and identifies the various physical components of the network camera for user reference.

Installation and Network Setup

Connecting the Network Cable

Detailed steps for properly routing and connecting the network cable to the camera's hermetic connector.

Physical Installation Guide

Instructions for securely mounting the camera, including wall/ceiling strength checks and drilling guidance.

Camera Configuration and Network Connection

Mounting Base and Camera Attachment

Steps for securing the mounting base and attaching the camera, including cable routing and base fixation.

Bracket Adjustment and SD Card Installation

Guidance on adjusting the camera's view angle after mounting and inserting a micro SD card for storage.

Accessing the Camera via IP-Tool

Procedure for connecting to the camera using the IP-Tool software, including IP address modification and browser access.