▐ 01 PURPOSE OF THIS MANUAL
◊ This manual applies exclusively to the solar photovoltaic module (here in after referred to
as Module) of TW solar energy Co., Ltd. (here in after referred to as TW). The contents of
this manual involve the installation methods, operation safety and maintenance
information of TW’s Modules.
◊ Modules must be installed by professionals. Please read this manual carefully before
installation. The installers must follow all the rules in this manual strictly as well as local
requirements and regulations by law or authorized organizations.
◊ Before installing, the installer must be familiar with their mechanical and electrical
requirements. Please keep this manual in a safe place for future reference (care and
maintenance) and in case of sale or disposal of the Modules.
▐ 02 DISCLAIMER
◊ TW shall not be responsible for any loss arising from the installation, operation, use or
maintenance of the Modules which is not complying with the guidance of this manual,
including breakdown or damage of the Modules or any other expenses incurred.
◊ Any customer shall not get any patent or authorization of the patent when using the
Modules, expressed or implied. Any infringement of patents or other rights of the third
party, which may result from the use of the Module, is not within the responsibility scope
of TW. The information in this manual is based on TW’s knowledge and experience and is
believed to be reliable, but such information including product specification (without
limitation) and relevant suggestions do not constitute a warranty, expressed or implied.
◊ TW reserves the rights to change the manual, the Modules, the specifications or any other
information of the Modules without prior notice.
▐ 03 SAFETY & TRANSPORT
3.1 General Detailed Rules
• Keep all the Modules and electrical connectors clean and dry before installation.
• Use both hands to carry Modules. Do not overlap Modules.
• Be cautious when carrying Modules. Slip-proof gloves are necessary.
• Use supportive disassembling tools when unpacking.
• The application level of TW module is Class A, which can be used in systems operating at
greater than 50V DC or 240W, where general contact access is anticipated.
To Next Page
Loading...