EasyManua.ls Logo

TWF SEM - Playpen Bottom Positions; Adjusting the Playpen Bottom; General Safety Instructions; Playpen Safety Guidelines

TWF SEM
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IMPORTANT !
KEEP FOR LATER REFERENCE
READ THESE INSTRUCTIONS CAREFULLY
First position , second position and last position of the bottom.
The bottom (E) can be placed in a high position using the 4 metal supports (40D). Put
them in the therefor designated holes (1 or 2). Secure the bottom (E) with the bolts (36A)
and nuts (5) onto the metal supports (40D). Make sure the identity sticker on the bottom
(E) faces downwards. When the child is old enough to crawl or can pull up itself you must
take out the bottom (E) and use the bottom (F) which is the last position of the bottom.
General safety instructions:
Maximum weight of the child for all bottom positions: 15 KG
Warning: Do not place the playpen close to an open fire or other heat source.
Warning: Do
n't leave anything in the playpen that could endanger the child.
Warning:
Do
n't leave anything in the playpen that the child could use as a stair.
Warning: Don't leave anything in the playpen that could cause suffocation or entanglement
of the child.
Make sure the identity sticker on the bottom (E) faces downwards.
Check regularly that the bolts (36A) on the corners and the 4 nuts (5) of the adjustable
bottom are properly tightened.
Warning: never use more than 1 mattress in the playpen.
Recommendation for the maximum dimensions of the mattress: l x w
x h = 93 cm x 71 cm x
11 cm and the recommended minimum dimensions of the mattress: l x w = 90 cm x 68 cm.
The space between the mattress and the bars is not allowed to be more than 30mm.
The distance from the top of the mattress to the top of the bars must be at least 500 mm in
the lowest position and at least 200 mm in the highest position. Do not use a mattress
thicker than 120mm. Take this into account when you purchase a mattress. The thickness
should be matched to these dimensions.
Ensure that the mattress does not exceed the indicated marking (P).
When the child is old enough to crawl or can pull up itself you
must take out the bottom (E)
and use the bottom (F) which is the last position of the bottom.
Warning: Do not use the playpen without the bottom
.
The playpen may not be used if a part of the box is broken, bent or missing.
Maintenance instructions: The playpen is maintenance-free. Use a slightly damp cloth and
a mild detergent to clean the playpen.
GB - PLAYPEN SEM
Warning: Never leave your child unsupervised.
When the child is able to climb out of the playpen, to prevent injury from falling, the playpen
shall no longer be used for that child.
Accessories which are not approved by the manufacturer shall not be used.
THIS PLAYPEN MEETS THE STANDARD EN 12227:2010