Two-Rock Custom Reverb - Lead Gain Control; Lead Master Control; Lead Channel Switch; Bypass Switch

Lead Gain- Adjusts the input level (gain) of the lead channel.
Lead master- Adjusts the output level of the lead channel.
Lead Channel Switch- Sends the instrument signal through the lead circut, adding extra stages of gain
to the signal and enabling the lead gain and lead master controls. To enable foot switch control of this
function, switch must be in the down position.
Bypass Switch- This switch bypasses the tone controls, increasing both level and mid-range response.
To enable footwitch control of this function, switch must be in the down position.
Reverb- The front panel reverb control is the return, or mix, control. The reverb effect is defeated with
this control in th efull counter clockwise position. Use in conjunction with the reverb drive control (see
REAR PANEL FUNCTIONS, next page).
Pre
sence- Adjusts the contour of high-frequency response. The high-frequency response will
increase as you advance the control clockwise.
Stand-by Switch- Should be in the “down” or “stand-by” position when you apply power to the unit.
After a few seconds, place the switch in the “up” position to use the amplifier. You may leave the unit
“powered up” and place this switch in the “stand-by” position to mute the output.
Indicator Lamp- This lamp will illuminate when the power switch is in the “up” position, indicating the
unit is receiving A/C power.
NOTE: All switches are ON in the “up” position
11.
12.
13.
14.
15.
16.
17.
18.