User Manual
To Our Valued Customers
Name of the each part of the product
Package Contents
The scale remover is designed to remove the scale inside of the water
ionizer. It is very important to handle this device with care in order to
properly descale and avoid malfunctions of the water ionizer. Please
read the following warnings carefully before using the device.
This device must be kept out of the reach of children
and must not be used by children without supervision.
Safety Precautions and Warnings
DO NOT USE any other substances other than the citric acid
provided by TYENT.
DO NOT DRINK the citric acid or citric acid water.
Keep the device out of reach of children
The method of using the scale remover for each water ionizer
model is different, so please read the user manual thoroughly
before using the device.
If the water outlet of the water ionizer is blocked due to scale,
the scale remover automatically stops or the connections may
be seperated due to internal pressure (Please contact the
service center)
If citric acid or scale substance remain in the scale remover
after use, it may cause malfunctions. Be sure to remove the
citric acid and scale substance thoroughly before storing.
Do not use on the wet floor.
※If placing the device on the sink, dry the floor before use.
Place the product on a flat surface to operate.
Do not use the device for more than 30 minutes continuously.
Do not spray water on the outside of device. It may cause
malfunctions.
Thank you for purchasing TYENT Scale remover. This device is for
scale removal and management that may be accumulated inside of
the water ionizer. Be sure to read this manual and use the product
correctly before using the scale remover.
Check the components after opening the package. Components are
subject to change in specification without prior notice in order to
improve the product performance.
Device
ø7 Connecting hose
ø10 Gender
Combined hose 2EA
*For UCE-PLUS only (see How to use)
*Use for direct connection to the
Drain hose (refer to “How to use)
※Read the manual before using and
cut it into appropriate length
Citric acid(25g)
4EA
Skimming filter
5EA
How to use
DO NOT
operate the water ionizer while using the scale
remover.
For effective scale removal, the pump turns on/off automatically
repeated for 10 minutes.
※The pump operation sounds repeat on/off. It is not a malfunction.
If the connecting hose is blocked because of twisting during operation,
the device stops operation by the battery voltage.
Top cover
Inlet connection
Operation lamp
Operation button
Battery cover
※Connect with Drain
Outlet connection
※Connect with
alkaline water outlet
※Bottom
※LED’s on when device operates
908, Ungsang-daero, Yangsan-si, Gyeongsangnam-do, Korea
TEL 82.55.363.6670
ㅣ
E-mail. info@tyentgroup.com
MADE IN KOREA
www.tyentgroup.com
ø10
5/16″- 7/16″
1/4″- 3/8″ Connector
If the device is used in a humid place, it may cause the product failure.
Please do not use rechargeable batterie
s, be sure to use
1.5v Alkaline battery.
Remove the battery cover at the bottom and install the Battery(AA).
(After place the battery, be sure to close the battery cover.)
Check the filter is fixed inside of the scale remover.
Check the power plug of water ionizer before operating the scale remover.
Preparation before use
To Next Page
Need help?
General
