Why does my Tylo H2 Control Panel show a sauna temperature sensor failure?
A sauna temperature sensor failure on your Tylo Control Panel indicates that the thermistor in the sauna has either short-circuited or is not properly connected. You should check the cables and connections. If the problem persists, try replacing the thermistor.
What to do if Tylo H2 shows 'Power outage. Set time.'?
If your Tylo Control Panel displays 'Power outage. Set time,' it means the realtime timer has been reset. You should enter the current time and date to resolve this.
How to fix 'Lost contact with control panel' on my Tylo system?
If your Tylo Control Panel displays 'Lost contact with control panel,' try restarting the system. Also, check the cables and connections to ensure they are secure. If the issue continues, consider replacing the control panel.
What to do if Tylo H2 Control Panel lost contact with temperature/humidity sensor?
If your Tylo Control Panel has lost contact with the temperature/humidity sensor, try restarting the system. Check all cables and connections related to the sensor. If the problem persists, you might need to replace the sensor.
What does 'Hardware error. Contact service' mean on my Tylo Control Panel?
A 'Hardware error. Contact service' message on your Tylo Control Panel indicates that the realtime timer is not working. Try restarting the system. If the same error appears again, the circuit board in the control box may need to be replaced.
What does 'Firmware panic 0x%02x!' mean on my Tylo Control Panel?
A 'Firmware panic 0x%02x!' error on your Tylo Control Panel means that an error has occurred in the software. Try restarting the system. If the error continues, contact Service.
What to do if electronics in Tylo heater overheated?
If the electronics in your Tylo heater have overheated, it means the temperature in the control box circuit board is higher than 70 °C. Wait until the temperature drops below 70 °C.
Why does my Tylo Control Panel say there is more than one temperature sensor connected?
This message on your Tylo Control Panel indicates that more than one temperature sensor is connected to the heater network. Disconnect all sensors except one to resolve the issue.
General| Type | Control Panel |
|---|---|
| Model | H2 |
| Display | LCD |
| Power Supply | 24V DC |
| Operating Temperature | 0 - 50°C |
To Next Page
