TyloHelo A3 Series User Manual

INSTALLATION AND OPERATING INSTRUCTIONS
72-0105 01-24-2020 7013546 314 SKSM 219 C
Page 1
WARNING
SECTION 1: GENERAL INFORMATION
Do not take a sauna if using
alcohol, drugs or
medications.
Pregnant women or persons
with poor health should
consult their physician before
using any sauna.
Caution re hazard: Do not
use the sauna room for
drying clothes, bathing suits,
etc. Do not hang towels
above heater or place any
object other than the rocks
supplied on the heater. If any
darkening of the wall around
the heater is noticed
discontinue sauna use
immediately.
Inspect sauna regularly for
required maintenance to
heater, control and benches.
Replace wood surfaces
which show any signs of
deterioration.
The heater gets extremely hot
during operation and should
not be touched or burns may
result.
Minors should be adequately
supervised whenever near a
hot or warming sauna.
Vena/Fonda Pure 2.0/Trend/A3 Series Heater
with BWT
Models 4.5, 6.0, 8.0
(Model #'s 1712-450-1706, 1712-600-1706, 1712-800-1706)
with Pure 2.0 Control (Model 1601-40 and 1601-40-1).
Read all instructions carefully before installation. Please leave all
instructions and warranty with the owner.
WARNING
Prolonged exposure to elevated temperatures is capable of inducing
hyperthermia. Hyperthermia occurs when the internal temperature of the
body reaches several degrees above the normal body temperature of
98.6°F. The symptoms of hyperthermia include an increase in the normal
temperature of the body, dizziness, lethargy, drowsiness, and fainting. The
effects of the hyperthermia include failure to perceive heat, failure to
recognize the need to exit the room, unawareness of impending hazard,
fetal damage in pregnant women, physical inability to exit the room and
unconsciousness.
WARNING
The use of alcohol, drugs, or medication is capable of greatly increasing
the risk of fatal hyperthermia.
These heaters are ETL approved by Intertek for permanent installations and
electrical connections. Built with splash proof construction, the conducting
parts are protected against water. All wiring must be performed in
accordance with national and local codes. See Diagram 2 for wire and
room size requirements. These heaters are wall mounted.

TyloHelo A3 Series Specifications

General

Brand	TyloHelo
Model	A3 Series
Category	Heater
Language	English

Summary

General Information and Safety

Hyperthermia and Temperature Exposure Risks

Prolonged exposure to high temperatures can cause hyperthermia with severe symptoms.

Alcohol, Drugs, and Medication Risks

Using these substances increases the risk of fatal hyperthermia.

General Sauna Use Precautions

Includes warnings about alcohol, pregnancy, fire hazards, hot surfaces, and supervision.

Installation Procedures

Heater Mounting and Electrical Hook-Up

Instructions for mounting the heater and requirements for electrical installation.

Rock Placement and Heater Guard

Proper rock placement for performance and installing a heater guard for safety.

Temperature Sensor Installation

Guidelines for routing and connecting the low-voltage sensor wire.

Control Installation and Operation

Control Unit Placement and Wiring

Instructions for installing the control unit, including cable routing.

Operating the Control Panel

How to turn on the light, set temperature, and select sauna length.

Temperature Display and Start Options

Changing temperature units (F/C) and starting heat immediately or with a delay.

Safety, Maintenance, and Troubleshooting

High Limit Control Reset

Procedure to reset the high limit switch and when to contact service.

How to Take a Sauna

Guidelines for proper sauna use, including breaks and hydration.

Warning Placards and Room Construction

Instructions for placing warning placards and rules for sauna room construction.

Daily and Annual Maintenance

Procedures for cleaning the sauna room, heater, and replacing rocks.

BWT (Bio Water Technique) Usage

How to use the BWT system to increase sauna humidity.

Troubleshooting Fault Codes

Identifying and resolving issues using constant and flashing LED fault codes.