Lengthening or shortening the top link will change the angle of
the implement.The locating hole of the top link varies with the
type of implement used. The most common locations are the 1st
and 2nd hole from the top
►
►►
► ADJUSTMENT OF THE LIFT ROD (LEFT, RIGHT)
Adjust the length of the lift rod by screwing the Adjustable
Handle in or out. Adjust the length of the lift rod as necessary
to set the implement in its working position parallel
to the ground.
■ Adjusting the Lift Rod on the Lower Link
The position of the Lift Rod on the lower link must be
adjusted for different applications.The positions for various
applications are as follows:
– Lower Link
Hole D for Rotavator.
– Three Point Linkages
A three point linkage allows for the use of category II.
implements. And Hole diameter is 25.4mm.
►
►►
► TURNBUCKLE STABILIZERS ADJUSTMENT (CHECK LINK)
■ With the implement connected:
– Remove the pin ①
①①
① and to obtain
unrestricted lateral movement of the lift arms ②
②②
②
– Adjust the opening width of the arms ②
②②
② by positioning
the pin in one of the holes on the sleeve.
■ Without the implement:
– Extract the pin ①
①①
①, move the sliding sleeve fully back
against the support.
– With the arms lowered, adjust the opening so that
the lift rods are in the vertical position..
To Next Page
Loading...
