►
►►
► SYSTEM CONFIGULATION
1.The heating system consist of two units:
1-Electric heater and blower unit installed behind roof console.
2-Power supplying set, consisting of an auxiliary alternator located front of the engine
and driven by a belt directly linked to the engine pulley.
If the air does not come out from the diffusers right away as soon as the system is started, turn off
immediately and identify the fault.
N.B-Never turn on the heating system when working in dusty environments.
Warning
Before starting the engine, make sure the system is off
(by turning off the ventilation fan) so as not to overload the battery.
After the system at full power for a long period of time, never turn it off suddenly
but let it first idle for about 20 seconds.
Check the compressor belt tension regularly and adjust
if required.
The correct tension is if the center of the belt is pushed With
a finger it moves in approx. 10 mm (0.39 in)as shown in the
picture. To adjust the belt, loosen or tighten the nut as shown
in the picture.
To Next Page
Loading...
