69
Fuel Filter Element
Water separator
Fuel Cock
BLEEDING THE FUEL SYSTEM
1. Fuel Tank
2. Water separator
5. Fuel injection pump
3. Fuel feed pump
4. Fuel filter
1) Fill the tank with fuel and turn the
ignition key to on.
2) Loosen the air breather screw of the fuel filter
two or three turns.
3) When fuel free from air flows (bubbles) from the
Air breather screw, tighten the Air breath screw.
4) The bleeding of the system is now finished.
CLEANING OIL WATER SEPARATOR OF
FUEL FILTER
If any foreign material or water is
seen through the sight glass, remove
it by performing the following steps
1. Prepare a container to collect fuel
from the oil water separator.
2. Open the drain plug.
3. After a sufficient amount of fuel
is drained, tighten the drain plug
with a hand.
4. Do not use any tool.
Fuel Feed Pump
To Next Page
Loading...
