71
BLEEDING THE FUEL SYSTEM
CHANGING THE OILS IN THE TRACTOR
Always use quality oils as engine or transmission oil (refer to the page 66)
Refer to the table on page 66,67 and 68 for the change frequency.
► CHANGING ENGINE OIL
Park tractor on level surface, shut-off engine
Remove sump plug & drain oil.
Replace and check the sump plug and refill the engine
with oil to the correct level on the dipstick
approx. 5.3ℓ(1.4 US gal)
The grade of oil to be used will depend on the ambient
temperature.
The tractor is shipped from the factory with 15W/40
For summer use over 77℉ use SAE 30
For temperatures from 32℉-77℉ use SAE20 or 15W/40
For temperatures below 32℉ use SAE 10W
1) Fill the tank with fuel and turn the
ignition key to on.
2) Loosen the air breather screw of the fuel filter
two or three turns.
3) When fuel free from air flows (bubbles) from the
Air breather screw, tighten the Air breath screw.
4) The bleeding of the system is now finished.
Engine Oil Filter
Engine Oil Filter
Fuel filter Water Separator(1
st
)
Fuel Filter(2
nd
)
Fuel Supply Pump
Fuel Tank
1. Water separator
Fuel injection pump
3. Fuel feed pump
2. Fuel filter
To Next Page
Loading...
