TYM T903 - Page 39

►
►►
► ERROR CODES
If a fault occurs with the 3 Point-Linkage or Tractor’s System, Display shows the associated code as below.
Should fine the Trouble cause and be repaired immediately.
Fault
code
Description
11 Indicates Circuit Fault of the Lift Arm solenoid for Raising
12 Indicates Circuit Fault of the Lift Arm solenoid for Lowering
13 Indicates Short Fault of the Lift Solenoid for Raising/Lowering
14 Indicates Connecting Fault of the Exterior (raise and Lower) control button for Raising
15 Indicates Connecting Fault of the Exterior (raise and Lower) control button for Lowering
16 Indicate Power Supply Fault of the Lift Arm Controller (In short Circuit to +10V)
17 Indicate Power Supply Fault of the Lift Arm Controller (In short Circuit over +16V)
22 Indicates Position Sensor Fault
31 Indicates Left Daft Sensor Fault
32 Indicates Right Daft Sensor Fault
1301
Pressure too low at Hydraulic Clutch
38
1301
Pressure too low at Hydraulic Clutch
1401 Short or Connecting fault at Over-run of front wheel drive Solenoid
1402 Short or Connecting fault at 4WD drive Solenoid
1403 Short or Connecting fault at Power shift (High/Low speed) Solenoid
1405 Short or Connecting fault at Forward Drive Terminal Solenoid
1406 Short or Connecting fault at Reverse Drive Terminal Solenoid
2301 Short or Connecting fault at Shuttle S/W