PAGE 6 OF 21 0421 IH-8931
OPERATION CONTINUED
3. Liquids may be emptied through tank drain. To
empty, turn off unit and remove plug from wall
outlet. Remove drain cap and deposit liquid waste
contents in suitable drain. After tank is empty, return
drain cap to its original position. To continue use,
plug cord into wall outlet and turn on the unit.
(See Figure 6)
BLOWING OPERATION
WARNING: Always wear safety goggles
complying with ANSI Z87.1 (or in Canada
CSA Z94.3) when using as a blower.
WARNING: To avoid injury to bystanders, keep
them clear of blowing debris.
CAUTION: Wear a dust mask if blowing creates
dust that might be inhaled.
CAUTION: To reduce the risk of hearing loss,
wear ear protectors when using the vacuum/
blower for extended hours or when using it in a
noisy area.
1. Locate blowing port on the vacuum.
2. Insert one end of the 1⁄" x 7' hose into the blowing
port. (See Figure 7)
3. Turn vacuum "ON".
Figure 6
Drain
Figure 7
Blowing
Port
To Next Page
Loading...
Need help?
General
