U-Line H-8667 - Cover Assembly

PAGE 2 OF 12 0321 IH-8667
ASSEMBLY CONTINUED
2. Assemble the center frame first and then assemble
each side. (See Figure 2)
NOTE: Attach the cover before inserting the legs.
NOTE: Do not connect leg poles at this point.
COVER ASSEMBLY
1. Unfold the cover with the grommets toward the
cover's bottom and place over the frame. The flared
edges should be located at each of the four corners
of the frame.
2. Begin attaching the cover with the elastic ball
straps by inserting the elastic cord of the ball strap
underneath the cover and through the grommet.
Pull cord taut until ball stops. Wrap cord around
pole and under ball. This will hide the ball under the
cover and provide a more finished look to the unit.
(See Figure 3)
NOTE: The ball straps are long enough to
accommodate various cover lengths. If the straps
need a tighter fit, they can be shortened by
making an additional knot in the cord strap. Slide
the ball upward to reveal the tied knot. Tie a new
knot above the old one. The size of the knot will
determine how short the strap becomes. Slip the
ball down over the new knot and secure.
3. Attach two elastic ball straps at each of the four
corners. (See Figure 4)
4. Continue attaching straps from left to right in a
zigzag pattern down both sides of the canopy.
(See Figure 5)
5. Attach straps at the front and back of the unit, again
using a zigzag pattern until all straps are secured.
(See Figure 6)
Figure 4
Figure 5
Figure 6
Figure 3
Figure 2
78"
68"
Assemble center
of frame first.
Side
Front
Start at
corners.
Attach straps
from left to right.
Inside Outside
Attach straps from
front to back.