PAGE 2 OF 3 0316 IH-5598
INSTALLATION CONTINUED
3. Slide the cap catch bin onto the mounting bracket.
(See Figure 2)
4. Connect the lid by pushing the three pins into the
clips located on the cooler. (See Figure 3)
5. Flip the base upside down to install the rigid casters
using the caster mounting hardware. (See Figure 4)
6. Ensure both rigid casters are installed on the same
side of the base. (See Figure 4)
7. While the base is upside down, place the bolts
through the caster holes from the top. From the
bottom, secure the washer on the bolt followed by
the nut and tighten using a wrench and the Phillips
screwdriver. (See Figure 4)
8. Repeat on the other side of the base with the
locking casters.
9. Place cooler onto the base ensuring the Igloo logo
on the base is on the same side as the cooler opens.
(See Figure 5)
Figure 2
Figure 3
Figure 5
Figure 4
Locking
Casters
Rigid
Casters
Igloo
Logo
To Next Page
Loading...