U-Line Igloo Party Bar - User Manual

PAGE 1 OF 3 0316 IH-5598
π H-5598
IGLOO PARTY BAR
1-800-295-5510
uline.com
PARTS
INSTALLATION
Lid x 1
Rigid
Caster x 2
Long Screws
Mounting
Bracket
Cooler
Locking
Caster x 2
Caster Mounting
Hardware x 16
Bottle
Opener x 1
Short
Screw x 2
Long
Screw x 2
Cap Catch
Bin x 1
Mounting
Bracket x 1
Cooler x 1
Base x 1
1. Remove two short screws and bottle opener from
bag. Line up the bottle opener with the two most
upper holes. Using the Phillips screwdriver, tighten
the short screws into the cooler. (See Figure 1)
NOTE: The holes are not pre-cut, but are
marked with indentations in the cooler wall.
2. Attach mounting bracket to cooler wall using the two
long screws. Make sure mounting bracket is upright
(See Figure 1)
NOTE: the holes are not pre-cut, but are
marked with indentations in the cooler wall.
Wrench Phillips
Screwdriver
TOOLS NEEDED
Figure 1
Short
Screws

U-Line Igloo Party Bar Specifications

General

Brand	U-Line
Model	Igloo Party Bar
Category	Accessories
Language	English

Summary

Installation Steps

Attach Bottle Opener

Lines up the bottle opener with upper holes and tightens short screws into the cooler wall.

Attach Mounting Bracket

Secures the mounting bracket to the cooler wall using two long screws, ensuring it is upright.

Continued Installation

Install Cap Catch Bin and Connect Lid

Slides the cap catch bin onto the mounting bracket and connects the lid to the cooler via pins.

Install Casters and Secure Base

Installs rigid and locking casters onto the base, securing them with hardware, then places the cooler onto the base.

Final Installation and Safety

Install Batteries

Removes the battery cover, installs four AA batteries, and secures the cover using a Phillips screwdriver.

General Safety Precautions

Provides essential safety advice for using and handling the Igloo cooler to prevent injury or damage.