What to do if my U.S. Products HHP-300 has no spray?
If your U.S. Products Scrubber is not spraying, several issues could be the cause. First, make sure the solution tank is full. If it is, check the spray tip for clogs and clean it if necessary. Also, verify that the pump is running and properly primed. Finally, inspect the valve on the wand to ensure it's operating correctly; repair if needed.
Why does my U.S. Products HHP-300 have low suction?
Low suction in your U.S. Products Scrubber can arise from a few common issues. Check the cleaning tool and vacuum hose for any debris that might be causing a blockage and clear it. Also, ensure the drain gate is completely closed and that its seals aren't damaged; fix or replace them as needed. Finally, make sure the vacuum dome is correctly seated and undamaged; re-seat or replace if necessary.
What to do if U.S. Products HHP-300 pump does not run?
If the pump on your U.S. Products Scrubber isn't running, there are a few things to investigate. Start by checking the brushes in the pump motor and replace them if they are worn. Next, ensure that the pump is receiving power. Also, test the Motor Speed Control Circuit Board and potentiometer; replace if necessary.
What to do if U.S. Products Scrubber has low heat or no heat?
If your U.S. Products Scrubber is producing low heat or no heat, consider these potential causes. Try spraying for shorter cycles of 12-15 seconds each. Flush the heat exchanger. Ensure you're using the correct tool and reduce the water flow. Use a standard length and diameter hose. Confirm that the heat is turned on, indicated by the green light or the bypass switch. Check the wall outlet for power, ensuring the breaker hasn't tripped. Check wiring for ‘opens’ if there is no power to the bypass switch.
What to do if my U.S. Products Scrubber has no suction?
If your U.S. Products Scrubber isn't producing any suction, begin by ensuring the motor is receiving power. You should also test the electronic float, switch, vacuum motor, and vacuum circuit board, replacing any of these components if necessary.
Key operating precautions and warnings before initial use.
Precautions to prevent electric shock and related dangers.
Guidelines for safe operation, storage, and environmental conditions.
Guidance on unpacking, inspection, and chemical usage for cleaning.
Daily flushing, monthly maintenance, and lubrication advice.
Description of the HHP-300 switch plate controls.
Explanation of the circuit locator and bypass switch.
Step-by-step guide for filling, plugging in, and priming.
Auto vacuum shutoff mechanism and pump pressure adjustment.
Detailed list of replacement parts for the HHP-300.
Solutions for common machine operational issues.
Technical specifications and warranty summary.
General| Model | HHP-300 |
|---|---|
| Category | Scrubber |
| Power Source | Battery |
| Battery Voltage | 12 V |
| Flow Rate | 1.5 GPM |
| Battery Type | Lead Acid |
To Next Page
