Need help?Do you have a question about the U-tec Ultraloq U-Bolt Pro Z-Wave and is the answer not in the manual?
General| Type | Smart Lock |
|---|---|
| Lock Type | Deadbolt |
| Keyless Entry | Yes |
| Fingerprint Recognition | Yes |
| Mobile App | Yes |
| Battery Life | Up to 12 months |
| Material | Zinc Alloy |
| User Codes | Yes |
| Fingerprint Storage | Up to 120 |
| Power | 4 AA batteries |
| Backset | 2.75 inches |
| Certification | ANSI/BHMA Grade 2 |
| Fingerprint Capacity | Up to 120 |
| PIN Code Capacity | Up to 100 |
| Auto-Lock | Yes |
| Backup Key | Yes |
| Compatibility | Z-Wave compatible hubs |
| Connectivity | Z-Wave, Bluetooth |
| Weather Resistance | IP65 |
| Operating Temperature | -4°F to 140°F |
| Unlock Methods | Fingerprint, PIN, Mobile App, Key |
| Installation | Easy installation |
Watch an installation video by scanning a QR code or visiting a website.
Measure and confirm door dimensions for proper lock installation.
Install the bolt into the door, ensuring the UP icon faces correctly.
Install the strike plate into the door frame.
Keep bolt retracted and tailpiece horizontal; do not insert key.
Align sticks with bolt holes and route cable below the bolt.
Route the cable through the hole on the Interior Assembly Mounting Plate.
Secure the Interior Assembly Mounting Plate using Screws D.
Remove the battery cover from the Interior Assembly.
Insert the cable connector into the socket, ensuring white teeth face up.
Rotate the knob to a vertical position to keep the lock unlocked.
Attach the Interior Assembly to the Mounting Plate and tighten Screws E.
Rotate the knob to a horizontal position to keep the lock locked.
Insert 4 AA Alkaline Batteries and install the battery cover.
Watch a step-by-step video for using the Ultraloq U-Bolt Pro Z-Wave.
Details of the exterior components and their functions.
Used to reset the lock to factory default settings.
Compartments for inserting 4 AA alkaline batteries.
Used to unlock and lock the door from inside.
Turns red when the door is unlocked.
Alerts for low battery status with LED and beeps.
Steps to register an account and add the lock in the U-tec App.
Instructions for adding the smart lock to a Z-Wave hub.
Enter a 4-8 digit code and press Ultraloq Button to unlock.
Place your finger on the Fingerprint Reader to unlock.
Unlock through your hub interface when connected.
Use your U-tec App to unlock. Refer to the App for details.
Press Ultraloq Button to lock manually or enable Auto Lock.
Rotate the knob to a vertical position to unlock.
Use 4 high-quality alkaline AA batteries for replacement.
Use a 5V power bank to activate the lock when batteries are dead.
Use the backup key to override and unlock the lock.
Enable or disable the automatic re-locking feature.
Use up to 16-digit Vague Code for entry.
Tips for optimal fingerprint recognition and enrollment.
Steps to create an Admin Code in Standalone Mode.
Steps to add a User Code in Standalone Mode.
Steps to add fingerprints in Standalone Mode.
Reset the lock to Factory Default Mode to delete Admin and Users.
Steps to remove the lock from a Z-Wave hub.
Procedure to reset the lock to factory defaults.
Confirms U-tec App usability with a Z-Wave hub.
Instructions for account recovery if the smartphone is lost.
Solutions for unlocking when the battery is dead.
Explains user roles and their privileges.
Recommendation on using original accessories for best performance.
Information on the maximum number of logs supported.
Details on the maximum number of users and their registrations.
Explains Z-Wave lock connectivity with WiFi networks.
To Next Page
