UAZ 469B User Manual

Prepare the new automobile for use, including depreservation if needed.

Do not rev cold engine; warm up to 60°C before moving. Maintain 80-90°C.

Disengage front axle on dry hard-surface roads.

Lists cylinder bore, stroke, displacement, compression, power, and torque.

Details fuel, lubrication, cooling, clutch, gearbox, transfer case, and axle specs.

Information on chassis and engine number locations and plates.

Describes speedometer, odometer, ammeter, and warning lamps.

Details oil pressure, coolant temperature, fuel level gauges, and warning lamps.

Critical period for vehicle longevity; avoid overloading and exceeding speed limits.

Tasks after the initial 1000 km, including tightening nuts and checking clearances.

Information on oil level, pressure, and related components.

Specifies required oil pressure at various engine conditions.

Procedures for topping up coolant and maintaining optimal operating temperature.

Details on carburettor operation, fuel level check, and adjustment procedures.

Checking and adjusting ignition timing based on octane selector.

Procedure for torque tightening cylinder head nuts.

Detailed steps for cold engine valve clearance adjustment.

Steps for starting the engine in temperatures above 0°C.

Specific procedures for starting in moderately cold temperatures.

Special procedures for starting in very cold conditions.

Procedure for starting a warm engine and troubleshooting hot start failures.

Specification and adjustment procedure for clutch pedal free travel.

Instructions for smooth shifting, downshifting, reverse, and first gear engagement.

Guidelines on when to engage front axle and low gear, including interlocks.

Checking oil level, replacing oil, tightening connections, and adjusting bearings.

Procedures for adjusting drive pinion and ring gear play.

Checking kingpin play, adjusting with shims, and inspecting related components.

Step-by-step guide for adjusting wheel bearings.

Tighten adjusting nut, check rotation, and secure with locknut.

Checking steering wheel play and adjusting roller-to-worm meshing.

Steps for adjusting service brakes using cams and checking pedal free travel.

Procedure for adjusting shoe-to-drum clearances.

Setting correct clearance for brake pedal free travel.

Procedure for filling the brake system with fluid and bleeding air.

Steps for filling master cylinder and bleeding air from the system.

Procedure for adjusting brake shoe clearance.

Steps to adjust the length of the parking brake control rod.

Details on alternator voltage, regulator, and operating instructions.

Description of starter operation, limits, and maintenance steps.

Maximum starter operation time and sequence.

Checking terminals, commutator, relay, and mounting.

Unit description and procedures for aiming symmetric and asymmetric beams.

Essential pre-drive checks for safe operation.

Details for 2,000, 4,000, 8,000, and 16,000 km service intervals.

Checks for fan belt, battery, tyres, lubrication, and trial run.

Covers 4,000 km tasks plus steering, brakes, ignition, and battery checks.

Includes 8,000 km tasks plus engine compression and valve checks.

Comprehensive guide to preparing the vehicle for long-term storage.