Ubee Interactive — www.ubeeinteractive.com
3 Ubee DVW32CB – Safety and Installation Product Insert v1.0
such as radiators or stoves.
5. Clean the device only with a clean, dry cloth.
Do not use liquid or chemical cleaners.
6. Avoid static discharge when touching the
device by first touching the coaxial connector
of the coaxial cable.
7. Installation of the device should include
grounding the coaxial cable to the earth at the
building entrance per ANSI/NFPA 70 and the
National Electrical Code (NEC, in particular,
Section 820.93, Grounding of the Outer
Conductive Shield of a Coaxial Cable). The
device is designed for IT power systems with
phase-to-phase voltage at 90~132VAC.
8.
Disconnecting the Device
: If the device
becomes damaged or encounters some other
abnormality, disconnect the power plug from
the AC wall outlet immediately.
9. The device should be installed in a location
not to exceed the maximum temperature of
40 degrees Celsius (104 degrees
Fahrenheit).
10. When this device is placed upright with the
aid of the stand, the stand must be fixed at a
90-degree angle to the device. Otherwise, the
device will have the risk of tipping over.
11. Keep the device away from Children and
Pets.
12. Place the device on a cool surface. Failure to
do so may result in overheating which can
cause extreme damage.
13. Do not modify or attempt to disassemble the
device. Use it only according to the
instructions.
14. Do not dispose of the device in a trash
container. Please recycle.
15. This product must be installed upright.
To Next Page
Loading...
Need help?
General
