UE Systems VOLUME 1.3 - Specifications

SPECIFICATIONS
Construction: Hand held ABS pistol type ultrasonic processor
stainless steel sensor enclosures
Circuitry: SMD/Solid State hybrid hetrodyne receiver
Frequency Response: 20-100 kHz (centered at 28-42 kHz)
Indicator: 10 segment LED bargraph (red)
Sensitivity Selection: 8 position precision attenuation
Power: 9 volt alkaline battery
Low Battery
Voltage Indicator: LED
Headset: Noise isolating type: double headset wired monophonic
Impedence: 16 ohms. Over 23 dB noise attenuation.
Meets or exceeds ANSI specifications and OSHA standards.
Transmitter: Patented warble tone transmission.
Response time: 300 m. sec.
Ambient Operating
Temperature Range: 32
o
- 120
o
F(0
o
- 50
o
C)
Relative Humidity: 10 - 95% noncondensing at up to 86
o
F (30
o
C)
Storage Temperature: 0
o
- 130
o
F
Dimensions: 5.5" x 1" x 7.9"
Weight: 10 oz.
Probes:
Scanning Module (SCM-1): Stainless Steel unisonic (single transducer) piezo electric crystal type
Stethoscope (contact) Module: Stainless Steel plug-in type with 4.5" Stainless Steel waveguide
Rubber Focusing Probe: Circular shaped, shields stray ultrasound signals, focuses detected signals
Carrying Case: ABS plastic with die cut foam
Warranty: one year, parts/labor, excluding abuse(details available on request).