EN-10 EN-11
Operating the device Operating the device
• If you perform more than 30 measurements
without transferring the values to the myS-
ense app, the oldest value is deleted to make
room for a new measurement.
The device is now ready to perform a new meas-
urement (Figure 7). You will then hear another
beep.
Never begin a measurement before this mes-
sage appears on the display or before you hear
the second beep and the dash and °C icon ash
on the display. The thermometer must already
be in measurement mode when you start meas-
uring to be able to correctly record the progress
of the measurement.
Take the measurement within the selected measurement timeframe
immediately after waking up. Take the measurement even before you
get up. Measured values determined outside the measurement time-
frame will not be transferred to the mySense app.
You must have slept for at least ve hours before taking a measure-
ment and must not have stood up in the last hour before the meas-
urement. If you have not had enough sleep, skip the measurement.
• Place the probe tip underneath your tongue on either the left-hand
or right-hand side. The temperature sensor must make good con-
tact with the tissue.
• During the measurement, the current temperature is shown on the
display. You must wait until the measurement is complete to ensure
the accuracy of the temperature value.
• A long beep indicates that the measurement
is complete. The measurement value is shown
on the display (Figure 9).
• If the thermometer measures an elevated
temperature of 37.50°C or above, you will
hear 10 beeps in rapid succession. The display
switches between showing the temperature
and “HI” (fever alert, Figure 10).
• The device now tries to establish a Bluetooth
connection to transfer the measured value to
the mySense app. Make sure that the smart-
phone is within range, Bluetooth is enabled
and the mySense app is running.
• Close your mouth and breathe calmly through your nose so that
the measurement result is not aected by the air that you breathe.
• As long as the measured temperature re-
mains below the measuring range (32.00°C
to 43.99°C), the display shows L (low) (Figure
8). Have a little patience during the measure-
ment. The sensor must rst warm up from
room temperature to body temperature.
Measuring wake-up temperature
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
• If more than 25 saved measurements have
not been transferred to the mySense App, the
message “APP/FULL“ (Figures 5 and 6) appears
on the display to remind you to transfer the
measurement values to the app as soon as
possible.
Figure 5
To Next Page
Loading...
