UES Goliath Drawer Slide

To Next Page

www.goliathhardware.com.au

Tools: Tape Measure, Pencil, Ruler, Drill/Driver

Make sure the following are present:

Step 1: Measure and mark cabinet

Step 0: Before you begin

Step 2: Separating the internal member

Materials: Set of two Goliath Ball Bearing Full-Extension Drawer Slides sized to the inside depth of the cabinet.

Press lever to disconnect and separate internal

member from the rest of the drawer slide. Do this for

both drawer slides.

Align drawer units to where you want them to be on

the cabinet unit

With a pencil, measure and draw guides for the

positioning of the drawer runners on the cabinet unit.

Do the same for the other side of the cabinet unit.

Internal slide member

DRAWER SLIDE INSTALLATION GUIDE

Need help?

Do you have a question about the UES Goliath Drawer Slide and is the answer not in the manual?

Summary

Drawer Slide Preparation

Before You Begin

Ensure all necessary tools like tape measure, pencil, ruler, and drill/driver are present.

Materials Checklist

Verify a set of Goliath Ball Bearing Full-Extension Drawer Slides sized for the cabinet depth.

Cabinet Preparation and Marking

Measure and Mark Cabinet

Align drawer units and draw guides on the cabinet for precise runner positioning.

Drawer Slide Separation

Separate Internal Member

Press the release lever to disconnect and separate the internal member from the main drawer slide.

Attaching Drawer Slide Members

Attach Internal Member to Drawer Unit

Install the internal member vertically and parallel to the drawer side panel, allowing for adjustment.

Attach External Members to Cabinet

Mount the external slide members to the cabinet using provided screws, aligning with marked lines.

Final Assembly and Adjustment

Assemble Drawer to Cabinet

Insert the drawer into the cabinet and adjust slide members if necessary for smooth operation.