UFESA CC2000P - Function operation (ONLY by remote control)

22
Note: If not setting the temperature and weekly program, the product will automatically turn-o after 12
hours of continuous work, and enter into standby.
Function operation (ONLY by remote control)
1. Press ”
“, the product enter into working status. See below :A
2. Press ”
“ button for one time, the product works with low heating and display shows“-- / ” See
below : B. Press again, changes to high heating and display shows“--/
”.See below : C (figure 4)
3. The timer “
“ of remote control operate as same as the timer button on unit body.
4. Set current TIME/DAY (can set both under standby mode & working status):
Press ”
” button for one time, the display shows ”12“ as default,press “ / “ to set current hour;
press “
“ again, the display shows minute “ 30“, press ” / “ to set current minute ,then press
“
“ for third time, the display shows the day “ ”, press “ / “ to set current day (Monday-Sun-
day: d1-d7) . Then press” “ to confirm the setting, the display will show previous settings.
For example: Setting to Wednesday, 9:30 AM under 25 ºC under II heating, pls. refer to the following
photos: Figure 5
Note:
- After the product is power o,it needs to be reset, then press ”
“ to check the current time & day in
turn;
5. Set temperature
During working status, Press“
/ “,the display shows ” 23 “ as default. Press
”
/ “ to set desired temperature (temperature range 10-49 ºC), press ” “ to confirm the setting.
Set weekly proram(ONLY by remote control):
After complete setting of current TIME/DAY, below is the steps to set weekly program:
1) Press ”
“, the product enter into working status.
2) Press “
“,the display shows ”P“, it enter into weekly program setting:See below :A
3) .Press ”
“,the display shows d1~d7, set to working day(Monday-Sunday: d1~d7). Such as set Mon-
day:See below :B
Note:
In order to distinguish between setting current day & working day:
Current day - Monday-Sunday: d1~d7