UFESA SMART DIGITAL - User Manual

Questions and Answers

J
Joshua EdwardsAug 7, 2025
What to do if water runs out of the holes in the soleplate of my UFESA Ironing Center?
- L
  Lauren DennisAug 7, 2025
  If water runs out of the holes in the soleplate, it could be due to a couple of reasons. Firstly, water may have condensed in the pipes if you're using the ironing center for the first time or haven't used it recently. To resolve this, press the steam trigger away from your ironing board until the iron produces steam. Secondly, the soleplate might not be hot enough. In this case, wait until the iron soleplate reaches the appropriate temperature.
J
Jacqueline YoungAug 13, 2025
Why is there no steam coming from my UFESA Ironing Center?
- R
  ryangibsonAug 13, 2025
  If there's no steam or very little steam coming from your UFESA Ironing Center, there are a couple of possible causes. The water tank might be empty, so you should fill it. Alternatively, the soleplate might not be hot enough; wait until the iron soleplate is sufficiently heated.
H
heidistewartAug 22, 2025
What to do if my UFESA Ironing Center fails to heat up?
- M
  Matthew MayoAug 22, 2025
  If your UFESA Ironing Center fails to heat up and the power indicator light doesn't illuminate, the unit might not be properly plugged in. Ensure the unit is plugged into an electrical outlet.
M
Michael AdamsAug 29, 2025
Why are there brown streaks coming from my UFESA Ironing Center?
- J
  John OconnorAug 29, 2025
  If brown streaks are coming through the holes in the soleplate of your UFESA Ironing Center and staining the linen, it's likely because you're using chemical descaling agents or additives in the water. Never add these types of products to the water tank or steam chamber.