5
RX Mode Connection
Connecting to the one phone
1. Set the switch button to “RX”
2. Connect the product to your devices (e.g. amplifier, speaker) with the 3.5mm audio
cable
3. Plug USB-A of the product into a USB power source (e.g. PC/laptop, TV, charger)
and then the product will power on automatically with LED indicator glowing for 1
second and voice prompt saying “Power on”; subsequently, the product enters
pairing mode, LED indicator blinking blue and red alternately.
4. Search and connect to “UGREEN-60300” on the Bluetooth list of your phone, LED
indicator will blink blue slowly and voice prompt will say “Bluetooth connected” if
pairing is successful.
Connecting to two phones
1. According to “Connecting to one phone”, connect the product to the first phone
and turn off its Bluetooth.
2. Search and connect to “UGREEN-60300” on the second phone.
3. Turn on Bluetooth of the first phone and it will automatically reconnect to the
product Bluetooth (If it doesn’t reconnect, please operate manually from the
Bluetooht list)
4. Play music on either phone, if music plays normally, then it means that one-to-two
pairing successful.
Tip:
1. Press MFB once to play/pause music or take/end calls; press and hold MFB for 2
seconds to reject calls. All the functions are only available in RX mode.
2. After connected to two phones, you can only play music on one phone at a time.
When you need to switch to the other, please pause music on the first phone then
play music on the other one.
Bluetooth Connection Failure & Solution
When Bluetooth connection fails, make sure the product is turned on and press MFB five
times until LED glows solid blue for 5 seconds, indicating that resetting is successful.
To Next Page
Loading...
General