UGREEN PowerRoam User Manual

03
A B
· Please charge power station before initial use to activate.
· In order to ensure safety while charging, overcurrent protection will automatically trigger when the
input current exceeds the overcurrent protection value. When this happens, the Overcharge Protection
Switch will protrude. Once the overcurrent is abolished, press the switch to resume charging.
· If the power station shows a low battery, please recharge promptly. Refraining from prompt recharge
may result in the battery becoming inoperable.
Recharge with PowerZip Fast Charging 1200W Max Input Power
To charge power station via solar panels, use the following configuration:
Important Note
AC Recharging
Solar Recharging
AC Power Cable
2 X 100W/200W
Solar Panels
（not included）
Notes: 1. Up to 2 solar panels can be connected in series, maximum.
2. 400W is the maximum wattage rated power input for supported solar panels connected in series
(Additional cables not included).
1 X 100W/200W
Solar Panel
（not included）
or
EN

UGREEN PowerRoam Specifications

General

Output Power	1200W
Battery Type	LiFePO4
Cycle Life	3000 cycles to 80% capacity
Charging Methods	AC, Solar, Car
USB-C Output	100W Max
Solar Charging Input	200W Max
USB-A Output	18W
Car Output	12V/10A
AC Outlets	2 x 120V