8
TROUBLE SHOOTING
1. Q: Why does not the transmitter's LED light up when I press
the button on it ?
A: The battery power may be exhausted. Please replace the battery.
2. Q: Why can't the lock be unlocked after pressing the transmitter?
A: Please check the issue by the following steps:
a. Check whether the remote control receiver and transmitter are
paired successfully.
b. Check whether there is any metal object around the remote
control receiver as it may shield the signal.
3. Q: Why can't the lock work properly when the wiring is correct?
A: Please check whether the indicator of the receiver is on and the
mode of lock is selected correctly. (For more details, please
refer to "Lock Mode Select" in this manual.)
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.Any changes or
modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
FCC WARNING
To Next Page
Loading...
General