-2- USE INSTRUCTIONS TFS 100
21/38
6.2 WARNINGS AND DANGEROUS AREAS FOR THE
OPERATOR
In case of emergency, the operator must follow the instructions below:
The people working with this type of machines can be badly injured if they do
not follow the main rules for these machines.
The inadequate use of these machines can cause important damage in the
machine or in the products. This is why it is completely forbidden to modify the machine
if you are not qualified to do so.
The dangerous areas for the user are protected by means of a security system.
The manipulation of this system can cause problems for the user. If the system had to
be dismantled for maintenance or repairing purposes, the machine should be turned off
if possible. If this was not possible, the system must be installed immediately after the
maintenance or repairing work is finished. There are some dangerous areas which are
not protected by any security system. This is the case of the lower film inlet (where
clothes can get stuck) and also of all the mechanisms that move upwards and
downwards. These mechanisms will not be dangerous if the user works with all the
guards correctly placed. All the dangerous areas are marked with a specific danger
symbol.
These are the reasons why the user must examine the machine every day. This
must be done when starting the machine in search of any damage that can have a
negative influence on the security of the user. The worker, even if recently recruited,
must be familiarised with the security devices in order to be able to assure a correct
operation of the machine.
Press emergency button Disconnect main switch, close
compressed air, gas and water
Ask for help
To Next Page
Loading...
