1. Make sure the Spanner Ring (yellow) is
mounted correctly with the ridge in the bottom.
The Spanner Ring has to be mounted at all
times when using the Ultima Soft DGS.
4. Apply a waterbased lubricant onto the silicone
seal end, about 2cm wide. Do not use too little,
it is important that the whole seal slides easily.
3. Mount the seal on the ring. Pull it evenly until
the ridge on the seal and the ridge on the suit
ring are close together.
2. Turn the silicone wrist seal inside out and
make sure it is clean.
MOUNTING ULTIMA SOFT IN SI TECH ”SLÄGGÖ” ARM RINGS
To Next Page
Loading...