MOUNTING A LATEX OR NITRILE DRY GLOVE TO THE GLOVE RING
1. Put the glove ring in the glove and turn it as
shown in the image. Adjust the overlap to achieve
the correct length of the glove. Make sure to align
the glove mark to the center of protruding part on
the glove ring.
2. Mount the o-ring in the groove.
3. Fold the edge back over the o-ring and pull to
adjust the overlap.
Mount the cover ring and adjust it to fit in the
groove next to the o-ring.
Watch the instruction video on www.waterproof.eu
To Next Page
Loading...
Need help?
General