MOUNTING A PVC/FABRIC GLOVE TO THE GLOVE RING
1. First, mount the glove ring on the suit ring. Ask a
friend to hold the glove ring firmly during installation,
it is very difficult to do it on your own.
2. Place the o-ring inside the glove opening to the
desired length of the glove, and fold the edge
inwards.
3. Open the glove and o-ring by pulling with both
hands firmly to make it as large as possible.
4. Make sure to align the glove mark to the center of
protruding part on the glove ring. Use all four hands
to pull it over the ridge.
5. Check that the glove is correctly mounted and has
the desired length. Adjust the glove length and angle
by pulling the glove edge inside and at the same
time lifting the o-ring on the outside.
6. Mount the cover ring.
Watch the instruction video on www.waterproof.eu
Glove
Cover ring
Glove ring
O-ring
Note: If you have difficulties in assembling a
PVC/fabric glove on the glove ring, we recommend the
"Ultima Twist Assembly Tool". The practical assembly
tool from SplashLight GmbH allows you to mount the
glove effortlessly and easily.
To Next Page
Loading...
Need help?
General