7
FLIP-UP HELMET
GB
IE
Congratulations!
You have chosen a high-quality product with
your purchase. Familiarise yourself with the
product before use.
Please read the following instruction manual
carefully.
Only use the product as described and for
the indicated areas of use. Please store this
instruction manual safely. Please hand over all
the documentation when passing this product
to third parties.
Part designation
1. Top ventilation
2. Air outlet
3. Visor mechanism
4. Slider for sun shield
5. Flip-up part release
6. Front ventilation
7. Breath deector
8. Visor
9. Sun visor
10. Chin wind deector
11. Standard collar
12. Winter collar
13. Inner padding
14. Acoustic padding
15. Cheek pads
16. Chinstrap with snap-in fastener
Scope of delivery
The scope of delivery of your helmet consists
of:
• Additional pair of cheek pads for
individual size adjustment
• Acoustic padding
• Winter collar
• Helmet bag
• Instruction manual
Important information
This helmet has been designed for
motorcycling and manufactured according
to the latest technology. Despite the highest
safety standards, injuries can still occur in the
event of serious accidents. In some cases, the
impact may be so strong that the helmet does
not effectively protect the wearer from head
injuries.
In order to provide adequate protection,
this helmet must t snugly and be securely
fastened. Any helmet that has been subjected
to an intense impact must be replaced.
We guarantee that this product is free from
manufacturing and material defects. The
warranty claim does not apply to abrasion or
normal wear and tear and is void in the event
of improper handling.
For France, it is mandatory to have four
reector stickers on the helmet. These reector
stickers are included with your helmet. Apply
the stickers to both sides as well as to the front
and back of the helmet.
Instruction manual
Safety instructions
• Warning!
While riding, the helmet may only be
used with the chin part and visor closed.
• The helmet is equipped with a pivoting
sun shield which may only be used in
connection with a closed visor.
• To open the chin part, please press the
ip-up part release (5) while lifting the
chin part upward (Fig. B).
• To close the chin part, pull the chin part
down until it audibly locks into place.
• The helmet must t tightly and the
chinstrap must be rmly closed.
• Make sure that the air circulation is not
restricted.
• Make sure that the visor is always clean
and without any scratches. Damaged
visors must be replaced immediately.
PO-2024-28_Lidl_BDA_Klapphelm IAN 431649_Inside_LB8.indd 7PO-2024-28_Lidl_BDA_Klapphelm IAN 431649_Inside_LB8.indd 7 12.09.2023 16:29:2012.09.2023 16:29:20
To Next Page
Loading...