8
GB
IE
FLIP-UP HELMET
• Tinted visors must not be used at night or
in poor visibility conditions, as they restrict
the view. Up to ve years after the date
of purchase, you can reorder spare visors
from the mentioned service address, visor
number: 935V.
• No modications may be made to
the helmet, its structure or individual
components.
• The helmet must not be painted or have
stickers or labels attached to it.
• The helmet is designed to protect the head
in the event of an impact. After just a
single (even light) impact, this protection is
no longer guaranteed. After an accident,
the helmet must therefore be replaced
immediately even if it has no visible
damage.
• The helmet must not be transported
hanging from the handlebars or any other
part of the machine. It is also essential
to keep it away from heated parts (e.g.
exhaust).
• Never use petroleum-based solvents or
abrasive cleaners to clean the helmet,
neither on the outside nor on the inside.
Always use a pH-neutral detergent diluted
in clear water. Rub gently with a soft
cloth. Then wipe dry with a lint-free cloth.
The padding can be cleaned using a little
bit of soap and a soft brush.
• Use only original spare parts for your
helmet.
• The sun shield may only be used in
daylight! It must not be used at dusk or at
night.
Product features
ECE-R 22.06
Homologation
This helmet meets the ECE-R 22.06 standard
and is homologated according to it.
The ECE-R 22.06 standard contains uniform
conditions for the approval of protective
helmets and their visors for drivers and
passengers of motorcycles and mopeds.
The basis for these tests are the so-called ECE
regulations of the United Nations
Economic Commission for Europe.
Essential tests of the ECE regulation
22.06
• Impact absorption
• Dynamic test of the retention system
• Testing the eld of vision
• Structural strength
• Retention test (detaching test)
• Chinstrap and lock testing
• Shear test for outer edges
• Test of the friction behaviour of the outer
shell
• Visor testing (mechanical and optical
properties)
• Chin impact, testing of the chin part
attenuation
Inner padding with Coolmax® inserts
Coolmax® from INVISTA is a high-
performance fabric bre that supports the
wearer during sports activities. Based on the
patented DuPont bre technology, Coolmax®
transports moisture from the body to the fabric
surface where it dries faster than any other
fabric. The specially developed bres from
INVISTA used for Coolmax® fabrics transport
moisture away from the body to the surface
of the fabric where it can evaporate quickly.
At the same time, the uniquely shaped bres
provide maximum breathability even when
wet. In addition, the breathability improves the
thermoregulatory effect.
In this product, cheek, forehead and neck pads
are equipped with Coolmax®.
HeiQ Pure
Textile freshness
Experience the feeling of lasting freshness
thanks to the power of silver which keeps you
odour-free throughout the day.
The inner lining of the helmet contains a
biocidal agent (HeiQ Pure) for antibacterial
equipment of the inner lining. Active agent:
Silver chloride.
PO-2024-28_Lidl_BDA_Klapphelm IAN 431649_Inside_LB8.indd 8PO-2024-28_Lidl_BDA_Klapphelm IAN 431649_Inside_LB8.indd 8 12.09.2023 16:29:2012.09.2023 16:29:20
To Next Page
Loading...