ULTIMATE SPEED FF935SV - Page 7

8
9
FLIP-UP HELMET
GB IE
Breath deector and visor
ventilation
The breath deector (7) reduces
fogging of the visor that is caused
by breathing air. In addition, the
air circulation in the visor area is
improved.
Integrated sun shield
ABS
Impact-resistant ABS outer shell
Visor with anti-scratch coating
Additional winter comfort collar
Removable, washable inner lining
Changing the visor without tools
With an additional pair of cheek
pads for individual size adjustment
Suitable for eye-glass wearers
Safety snap-in fastener
Operating and assembly
instructions
Sun shield (Fig. C)
The integrated sun shield (9) allows you to
react quickly and easily to changing light
conditions.
The sun shield can be retracted and extended
via the slider (4).
Note:
• Make sure that the edge of the sun shield
does not obstruct your eld of vision.
• The sun shield may only be used with the
visor closed and only during the day.
Inner padding (Fig. D)
The inner padding (13) can be removed
completely and cleaned separately (see care
instructions).
To remove the inner padding, remove the
helmet collar and cheek pads rst. Then loosen
the rear snaps of the inner padding and pull
the clips of the inner padding out of the front of
the helmet.
Snap-in fastening system (Fig. E)
The snap-in fastener allows individual and
quick ne adjustment of the chinstrap.
Squeeze the snap-in fastener until the helmet
ts comfortably but rmly.
The sliding buckle allows the excess chinstrap
to be attached or secured.
Chin wind deector (Fig. F)
The chin wind deector (10) can be removed
or reattached as required. To attach the chin
wind deector, slide it into the ip-up part.
Cheek pads (Fig. G)
You will receive two pairs of the cheek pads
(15) with different thicknesses for individual
size adjustment.
The thinner cheek pads are pre-assembled
at the factory. The thicker cheek pads are
included separately with the helmet.
PO-2024-28_Lidl_BDA_Klapphelm IAN 431649_Inside_LB8.indd 9PO-2024-28_Lidl_BDA_Klapphelm IAN 431649_Inside_LB8.indd 9 12.09.2023 16:29:2012.09.2023 16:29:20