16 GB
Removing the connetion valve:
Connecting without valve adapter
10
: Open the clamp-
ing lever
8
for the connection valve
7
and remove
from the valve of the inflatable.
Connecting with valve adapter
10
: Remove the valve
adapter from the valve of the inflatable. Open the clamp-
ing lever
8
of the connection valve
7
and remove the
valve adapter
10
.
Note: Air may escape from the valve of the inflatable when
removing the connection valve
7
. Be sure not to remove
the connection valve
7
too quickly.
The manometer
2
is not calibrated. Therefore seek a
specialist facility with a calibrated device after inflating
inflatables where incorrect pressure can be dangerous
(e.g. car tyre).
Working instructions
This product is not suitable for continuous operation. It was
developed to produce air pressure, not air volume.
Do not use the product for longer than 5 minutes without
interruption to prevent overheating and damage to the
device. Afterwards allow to cool for a minimum of
20 minutes.
Checking the air pressure
Note: The device does not need to be connected to the
cigarette lighter to test air pressure.
Connect the connection valve
7
(see “Initial use“).
Read the air pressure on the display of the manometer
2
.
Remove the connection valve
7
once more (see “Initial
use“).
Note: The manometer
2
is not calibrated.
Attention: Please use a calibrated gauge if user needs an
accurate measurement.
Overload fuse
In the event of overuse or malfunction the overload fuse
11
in the cigarette lighter plug
5
will trip to protect the device.
To Next Page
Loading...
Need help?
General
