To Next PageTo Next Page
Need help?Do you have a question about the ULTIMATE SPEED USWB 22 A2 and is the answer not in the manual?
General| Brand | ULTIMATE SPEED |
|---|---|
| Model | USWB 22 A2 |
| Category | Automobile Accessories |
| Language | English |
Covers basic safety instructions for personal safety when working with the device.
Covers basic safety instructions for working with the device.
Covers electrical safety instructions to avoid accidents and injuries.
Covers specific safety instructions for the device's operation and use.
Details the procedure for connecting the EV charger to the power supply by an electrician.
Explains how to adjust the charge current using the rotary switch.
Details local load management and Master/Slave settings.
Explains how to set the address for the Smart Meter Gateway.
Describes the process for software updates performed by professionals.
Details Modbus communication via RS485 interface and registry table.
Steps to permanently deactivate RFID card access authorisation.
Steps to permanently activate RFID card access authorisation.
Procedure to exit basic settings mode and replace covers.
Instructions on how to start the charging process and connect the car.
How to select and set the charging current for single or three-phase connection.
Steps to correctly finish charging and disconnect the vehicle.
Describes behaviour during a voltage failure and recovery.
Troubleshooting steps for when the charging process fails to begin.
Explains why the set charging capacity might not be reached.
Reasons why the charger might not charge using three phases.
Details the terms and conditions of the product warranty.
Explains warranty duration and claims for defects.
Defines what is covered and excluded by the product warranty.
Instructions on how to submit and process warranty claims.
Provides contact details for customer service and support.
