To Next PageTo Next Page
Need help?Do you have a question about the Ultra Z Series and is the answer not in the manual?
Assembly for diverting water flow and operating the handle.
Secures the deck spout to the faucet body.
The primary control lever for water flow and temperature.
Component for mounting and securing valve assemblies.
Base structure for the faucet handle.
Structural components for the faucet base.
Device to mix air with water, reducing splash and flow.
The handheld spray unit for the tub.
Secures the hand shower hose or assembly.
Turn off water, remove guards, install spout with washer and secure with setscrew.
Insert and test the diverter knob and rod assembly connection.
Install bush/screw into hot valve, place washer, align handle/escutcheon, secure to valve.
Route hose through bracket, attach washer, guide, and secure assembly.
Remove aerator, turn on water supply, and flush debris for one minute.
Ensure diverter is down, turn handles on for flushing, then re-install aerator.
Remove parts before soldering, cover drain to prevent loss, operate within 0°C-55°C.
Warranty covers defects in workmanship and materials, excluding labor and misuse.
Contact toll-free customer service for additional assistance or service.
Assembly for diverting water flow and operating the handle.
Secures the deck spout to the faucet body.
The primary control lever for water flow and temperature.
Component for mounting and securing valve assemblies.
Base structure for the faucet handle.
Structural components for the faucet base.
Device to mix air with water, reducing splash and flow.
The handheld spray unit for the tub.
Secures the hand shower hose or assembly.
Turn off water, remove guards, install spout with washer and secure with setscrew.
Insert and test the diverter knob and rod assembly connection.
Install bush/screw into hot valve, place washer, align handle/escutcheon, secure to valve.
Route hose through bracket, attach washer, guide, and secure assembly.
Remove aerator, turn on water supply, and flush debris for one minute.
Ensure diverter is down, turn handles on for flushing, then re-install aerator.
Remove parts before soldering, cover drain to prevent loss, operate within 0°C-55°C.
Warranty covers defects in workmanship and materials, excluding labor and misuse.
Contact toll-free customer service for additional assistance or service.
General| Brand | Ultra |
|---|---|
| Model | Z Series |
| Category | Kitchen & Bath Fixtures |
| Language | English |
