10
For iMac/iMac DV and New Power Mac G3/G4 users
Configuring the Scan button Values
1. Click on the VistaAccess icon
in the control strip with
one mouse click. A pop -up
menu as shown on the right
appears.
2. Click the Push button
Configuration option. The Push Button
3. configuration window appears.
4. To Configure the Scanner button values. Select the image editing
software you want to scan to when you press the Scan Push button, and
the type of image you are scanning, the desired resolution, the scanning
intensity level, the size of the original image by clicking on the arrow to
the right in each field.
5. You could also click the check box “ Intelligent Image Process Engine”
in the “Push button Configuration” dialogue box to let the scanner do all
the settings for you automatically.
When you click the check box,
all relevant fields will turn gray
and the scanner does the correct Brightness setting.
6. Click the OK button to save the Scan Push Button configuration settings.
These settings will be used whenever you press the Scan button on the
front of the scanner.
7. Push the Scan button. The scanner will start the scanning process
and scan the image to the specified image editing software.
To Next Page
Loading...
Need help?
General
